MPP pipe

MPP pipe is also called MPP power cable protection pipe, which is divided into trenching type and non-trenching type. MPP non-trenching pipe is also called MPP jacking pipe or dragging pipe. MPP pipe uses modified polypropylene as the main raw material. It has the characteristics of high temperature resistance and external pressure resistance , and is suitable for medium and low voltage transmission line cable pipes below 10KV .

Product Introduction

MPP uses modified polypropylene as the main raw material. It is a construction project that does not require a large amount of dredging, digging, or damaging the road surface. It can lay pipelines and cables in special areas such as roads, railways, buildings, and riverbeds. Compared with the traditional ” trench digging and pipe laying method ” , the trenchless power pipe project is more in line with current environmental protection requirements, eliminating the dust and traffic congestion caused by traditional construction . This technology can also lay pipelines in some areas where excavation operations cannot be carried out, such as monument protection areas, downtown areas , crop and farmland protection areas, highways , rivers, etc.

Scope of application

It can be widely used in municipal, telecommunication, electricity, gas, tap water, heat and other pipeline projects.

Urban and rural non-excavation horizontal directional drilling power pipe drainage projects, and open excavation power pipe drainage projects.

Urban and rural non-excavation horizontal directional drilling sewerage and sewage pipe projects. Industrial wastewater discharge project.

Product superiority

1. MPPpipe has excellent electrical insulation .
2. MPPpipe has high heat deformation temperature and low temperature impact performance .
3. The tensile and compressive properties of MPP pipes are higher thanthose of HDPE .
4. MPP pipes are light, smooth,have low friction resistance, and can be hot-melt welded.
5. The long-termoperating temperatureof MPP pipe is -5 ~ 70℃ .
6. Construction instructions

During the transportation and construction of pipes, it is strictly prohibited to throw, hit, scratch or expose them to the sun. When hot-melt butting, the axes of the two tubes must be aligned, and the end faces must be cut vertically and flat. The processing temperature, time, and pressure will be adjusted accordingly depending on the climate conditions. The minimum bending radius of the pipe should be ≥75 pipe outer diameter.

Specifications